Hits
Balun 1:4 range to 3.5 29 MHz
Made from Amidon FT-114-43 core, 16 gauge speaker wire, and tie wraps
post 27 Jan 2024
Toroid & balun Links →
1:4 Guanella-Balun Current-Balun
The purpose of this article is to show how a 1:4 Guanella current balun changes an impedance level by a multiplier of four; for example, 50-ohm coax to a 200-ohm antenna
Constructing a 6:1 RF transformer
If it's using used a 50 Ohm coaxial transmission line, the main problem in constructing a 1:1 current balun using bifilar windings is that you have to get the impedance of the transmission line formed by the two parallel wires exactly correct
Balun & Chokes
I chose the LFB095051 ferrite tubes - sleeves with similar characteristics to the Mix31, therefore excellent for 80 and 160
9:1 Impedance Transformer
a 9:1 unbalanced to unbalanced UNUN impedance transformer, is to experiment with an Inverted V end fed antenna for 80 to 17m, I'm not aiming for transmission on 12 and 10m
209
The purpose of this article is to show how a 1:4 Guanella current balun changes an impedance level by a multiplier of four; for example, 50-ohm coax to a 200-ohm antenna
If it's using used a 50 Ohm coaxial transmission line, the main problem in constructing a 1:1 current balun using bifilar windings is that you have to get the impedance of the transmission line formed by the two parallel wires exactly correct
I chose the LFB095051 ferrite tubes - sleeves with similar characteristics to the Mix31, therefore excellent for 80 and 160
a 9:1 unbalanced to unbalanced UNUN impedance transformer, is to experiment with an Inverted V end fed antenna for 80 to 17m, I'm not aiming for transmission on 12 and 10m
Take off angle of horizontal antenna For horizontal polarization, the electric field will move sideways on a horizontal plane, while for vertical polarization it will oscillate up and down on a vertical plane
Build a Three-Way Antenna Switch and Displa To use a wireless relay to select one of two high current capacity power relays
Calculo da Antena Bazooka A double bazooka antenna is a combination that has a complete coaxial wave multiplied by its velocity factor and a total end-to-end length of 1/4 wave for each side affected by another driver shortening factor