2002 - 2020 i1wqrlinkradio.com

Un bal-un di tensione 1:32

Hits

Un bal-un di tensione 1:32

La ricerca di un'antenna piu' silenziosa per la ricezione delle onde medie e delle HF mi ha spinto a realizzare il balun 1.32 che vi propongo
post 20 Nov 2019

Un bal-un di tensione 1:32




Toroid & balun Links


4 to 1 balun, VK5ZVS
This balun was made with two ferrite cores, Jaycar LF1258)wired using Cat 5 UTP wire. The winding ratio is 6 turns to 12 turns. 50 ohm primary is 6 turns. The 200 ohm secondary is formed by adding 3 turns to either end, giving 12 turns overal

6:1 Voltage Balun, VK6YSF
Requiring a balun to feed a balanced antenna from an un-balanced load with a impedance step up from 50ohms to 300ohms, a 1:6

9:1 transformer, KC7NOD
A balanced antenna from an un-balanced load with a impedance step up from 50ohms to 300ohms, a 1:6 Voltage balun design using two L15 ferrite toroid cores was selected

A 9:1 Balun For Your End Fed Antenna
unun transformer unbalanced to unbalanced. The raw End-Fed antenna will go through impedance swings as high as 5K Ohms,or more, at even multiples of its 1/4 wavelength design frequency

9 to 1 balun, VK5ZVS
This balun was made with single ferrite core, Jaycar L01234) wired using single strand Cat 5 UTP wire. The winding ratio is 6 turns to 18 turns. 50 ohm primary is 3 x 6 turns, wired in parallel. The 450 ohm secondary is formed by winding 2 x 9 turns in series