Hits
Choke balun 1:1
I used RG8 mini which seamlessly transfers 1kw. The balun should be mainly on the 160m band so I wound it on 2x 6 coaxial threads
post 19 Mar 2024
Toroid & balun Links →
4 to 1 balun
This balun was made with two ferrite cores, Jaycar LF1258)wired using Cat 5 UTP wire. The winding ratio is 6 turns to 12 turns. 50 ohm primary is 6 turns. The 200 ohm secondary is formed by adding 3 turns to either end, giving 12 turns overal
6:1 Voltage Balun
Requiring a balun to feed a balanced antenna from an un-balanced load with a impedance step up from 50ohms to 300ohms, a 1:6
9:1 transformer
A balanced antenna from an un-balanced load with a impedance step up from 50ohms to 300ohms, a 1:6 Voltage balun design using two L15 ferrite toroid cores was selected
9 to 1 balun
This balun was made with single ferrite core, Jaycar L01234) wired using single strand Cat 5 UTP wire. The winding ratio is 6 turns to 18 turns. 50 ohm primary is 3 x 6 turns, wired in parallel. The 450 ohm secondary is formed by winding 2 x 9 turns in series
209
This balun was made with two ferrite cores, Jaycar LF1258)wired using Cat 5 UTP wire. The winding ratio is 6 turns to 12 turns. 50 ohm primary is 6 turns. The 200 ohm secondary is formed by adding 3 turns to either end, giving 12 turns overal
Requiring a balun to feed a balanced antenna from an un-balanced load with a impedance step up from 50ohms to 300ohms, a 1:6
A balanced antenna from an un-balanced load with a impedance step up from 50ohms to 300ohms, a 1:6 Voltage balun design using two L15 ferrite toroid cores was selected
This balun was made with single ferrite core, Jaycar L01234) wired using single strand Cat 5 UTP wire. The winding ratio is 6 turns to 18 turns. 50 ohm primary is 3 x 6 turns, wired in parallel. The 450 ohm secondary is formed by winding 2 x 9 turns in series
Noise suppression with X-phase II This device similar devices are known as QRM eliminators or noise killers, makes it possible