Hits
Antenna Moxon for 7 MHz
My choice was to try a moxon wire antenna made by very thin wire to reduce weight
post 26 Jan 2024
Antenna Moxon Links →
40m Moxon yagi Antennna
In this antenna, 4 pieces of 6-7mt of fishing rod were used
10m Aluminium Moxon Construction
Bending the tubes was a challenge, I eventually borrowed a pipe bender for 15mm copper pipe and used this It worked satisfactorily and I used a hand held pipe cutter to cut the tubes
Six Meter Moxon Antenna
One fully portable 6m Moxon beam that breaks down into a bag easy carried off and easy to assemble in about ten minutes
20-meter Vertical Moxon
In the end the antenna ended up resonating closer to the upper edge of the 20m band around 14.275
Moxon for 70cm
The antenna is broadband, has a broad (100 degrees) front lobe, a good front-to-back ratio and a useful amount of forward gain and presents a decent near 50 ohm match at resonance
42
In this antenna, 4 pieces of 6-7mt of fishing rod were used
Bending the tubes was a challenge, I eventually borrowed a pipe bender for 15mm copper pipe and used this It worked satisfactorily and I used a hand held pipe cutter to cut the tubes
One fully portable 6m Moxon beam that breaks down into a bag easy carried off and easy to assemble in about ten minutes
In the end the antenna ended up resonating closer to the upper edge of the 20m band around 14.275
The antenna is broadband, has a broad (100 degrees) front lobe, a good front-to-back ratio and a useful amount of forward gain and presents a decent near 50 ohm match at resonance
Noise suppression with X-phase II This device similar devices are known as QRM eliminators or noise killers, makes it possible
The K9AY loop antenna for 160 and 80m bands You don't have the space to put up a 4 beverage antenna's, an ewe or a 4-square and want 'good ears' on 160 and 80m? no problems try a k9ay loop antenna
Spiderbeam 10-15-20m E' una Yagi tribanda full-size leggera, fatta di tubi in vetroresina e filo