Hits 

160 meter Half Sloper with radials


Half Sloper with a 160 meter coil simple concept. You take it to the top of the tower but under your 3 element beam which creates capacitance on the grounded side. Then obviously you load the center of the 50 ohm coax to the wire and slope it back down
post 28 Feb 2024
160 meter Half Sloper with radials

Antenna 160 meter Links

96



160m End Fed Antenna
The antenna is sported by a 22ft 6.7m central support and a 12ft 3.66 end support

Loaded Dipole for 160 Meter
Total Length 26 m 85 ft. Total Weight: 380 g Mesh constructed with enamelled wire 0.5 mm diameter Mesh-size 4 m x 2 m 13 x 6.5 ft

Morgain 160mt
The total length of each of the radiator halves is about 60 m. They are folded three times, as shown schematically

Inverted Ls and Vs Slopers Linear Loaded


Take off angle of horizontal antenna

Take off angle of horizontal antenna For horizontal polarization, the electric field will move sideways on a horizontal plane, while for vertical polarization it will oscillate up and down on a vertical plane

A remote antenna switch

A remote antenna switch An abiding dislike for bundles of cables running on the exterior of my house, so a remote antenna switch seemed like a good idea

5 element yagi antenna for 28.5 Mhz

5 element yagi antenna for 28.5 Mhz Gamma match will be made with a 1/2 "aluminum tube and a 75 cm coaxial piece of RG8 without sock and sheath inside the tube