GENERAL SPECIFICATIONS:
Architecture: DirectSampling DDC/DUCTransceiver
Interface: Mono-Block Inbuilt PC
Phase Noise (Clock): -149dB @ lOKhz
TCXO Stability (Typical): /- .1 PPM
Modes: CW, SSB, NFM, AM, Digital
Antenna Ports: 3 – BNC 50 ohm Software Configurable Ports, 2 – BNC ADC1 receive only
antenna ports, 1 – BNC Transverter receive only port, 1 – BNC for ADC2
Frequency Resolution: 1 Hz
ELECTRICAL SPECIFICATIONS:
13.8v DC@25A, 4A Rx/25ATx (13.8v 30A Supply recommended)
MECHANICAL SPECIFICATIONS:
6 Kg (approx. Weight)
Dimensions: 355MM (L) x 130MM (H) x 300MM (W) (Not including extrusions)
RECEIVER SPECIFICATIONS:
Receiver Architecture: Direct Down Conversion
Dual 16 bit Phase Synchronous ADCs
Independent filter banks for each ADC
6M LNAs
Frequency Coverage: 9Khz to 60Mhz
Attenuator: 1-30dB step attenuator
Reciprocal Mixing Dynamic Range (RMDR): 116dB@2Khz offset
Receiver Phase noise: -149dB @ lOKhz
Image rejection: 90dB
Hardware support for 7 independent receivers assignable toeither ADC
TRANSMITTER SPECIFICATIONS: Transmitter Architecture: Direct Up Conversion DAC Resolution: 16 bit RF Output Power: 100WSSB, CW, FM, RTTY, Digital; 1-30W AM IMD3 typically-68dB below PEP@100W output on 20M Harmonics: Typically better than-43dBc on HF and-60dBc on 6M Carrier and Opposite Sideband Suppression: Better than-80dBc Transverter IF Output: 0db to 15dB ADDITIONAL IO CONNECTIONS: RCA-Line In, PTT In, PTT Out, 2- DIG inputs DB9F – 7 Software Configurable Open Collector Outputs SMA-XVTR output, 10Mhz Reference Input 3.25mm Barrel Mic, CW Key, Headphones and two 6.25mm Speaker Outputs, SDR RJ-45 PC- USB 2.0 , USB 3.0, USB-C, Audio Barrel (PC), Wi-Fi SMA