Hits
160m mini portable End Fed
The setup for 160m and 40m using an end fed half wave tuner and a kite is simple and easy to setup
post 04 Mar 2024
Antenna End Fed Links →
End Fed Halfwave Antenna And Matching Unit
My favorite antenna for portable use is the end fed halfwave or EFHWA. I have documented some of the earlier ones I built in my pedestrian mobile pages
End fed Hertz
Installed the Dual Band L Network at the base of the antenna
End Fed Matcher
A 8:1 Transformer out of a piece of 18 ga. house wire. 24 turns as Secondary and 3 turns as primary on a T240 core
End Fed Antenna non risonante a carico lineare
End Fed da balcone dai 40 metri, ai 20 metri in 6 metri circa di lunghezza
End Fed Half Wave Antenna Coupler SWR bridge
End Fed Half Wave and a small coupler to use with my Rock-Mite. The coupler converts the high impedance end of the End Fed Half Wave antenna down to 50 ohms
64
My favorite antenna for portable use is the end fed halfwave or EFHWA. I have documented some of the earlier ones I built in my pedestrian mobile pages
Installed the Dual Band L Network at the base of the antenna
A 8:1 Transformer out of a piece of 18 ga. house wire. 24 turns as Secondary and 3 turns as primary on a T240 core
End Fed da balcone dai 40 metri, ai 20 metri in 6 metri circa di lunghezza
End Fed Half Wave and a small coupler to use with my Rock-Mite. The coupler converts the high impedance end of the End Fed Half Wave antenna down to 50 ohms
Linear loaded short dipole 21Mhz For my amateur radio activities on the HF bands I only have a 3.6 m wide balcony available for antennas. After some study I decided to experiment with a shortened dipole for the 15 m band
Rx antennas 4Square Rx Vertical Array My frequency design of 1.825 MHz a 90 degrees line would be 33,70 metersinstead of the previously calculated 33,27 m
A simple SWR Meter is to be used at HF An SWR meter provides information about how well matched is your antenna with the transmitter and how well power is being radiated