Building UHF Antennas

Building UHF Antennas
    The smooth part of a screwdriver handle makes a good form for bending both the balun and the dipole element
Hits 
post 18 Sep 2026



Antenna for UHF VHF Links →

147



A Portable Antenna for Mode B and J Satellites
    A 4:1 balun, constructed out of a 1/2 wavelength of RG-58 coax is used to couple the T match to the 50 ohm feedline


A turnstile antenna for 2-meter ARDF
    Designed by Jay Hennigan, WB6RDV, these are the same type of antennas I've been using for about seven years for both championship and practice ARDF These are horizontally polarized omindirectional antennas as specified in the IARU R1 ARDF rules


Antena Direcional para UHF - 430 - 450mhz
    The boom should be aluminum and rectangular. The diameter used in the antenna tested for this project was 2x2 cm and the total length was 1.80 meters


Antenna for 2m and 70cm
    Small antenna for 2m and 70cm, after using it you can roll-up the antenna, very nice on holidaysv


All Spectrum Electronic

All Spectrum Electronic All Spectrum Electronics Hobby Kits and Electronics Supply

dxengineering Ham Radio Equipment

Dxengineering Ham Radio Equipment DX Engineering Ham Radio Equipment & Supplies

BA-Electronics

BA-Electronics Ba-electronics, a division of products, has added electronic components, test equipment, wire, and supplies to its product offering