Hits
Emergency J-Pole Antenna
This is made from the old flat TV antenna wire
post 31 May 2024
Antenna jpole Links →
2 meter J-Pole
Cut the tubing to the size shown for the desired band. The only section where size is not critical is the mast section. Use any size you desire for mounting purposes
2 meter Aluminum Slim Jim Antenna
The Slim Jim is generally characterized as an end-fed vertical folded dipole. As with all end fed dipoles some sort of impedance matching is necessary to keep the SWR down
3 meter Slim-Jim Antenna
The gamma match consists of a 150mm length of 10mm aluminium tubing
Project antenna for 2 meter
The gamma match consists of a 150mm length of 10mm aluminium tubing
A slim antenna for vhf band
To build it I use pieces of 450 Ohms leader line approx. 154cm, a PVC tube approx. 200cm, rope,SO-239 female connector, RG-58 about 1,5meter
?>
81
Cut the tubing to the size shown for the desired band. The only section where size is not critical is the mast section. Use any size you desire for mounting purposes
The Slim Jim is generally characterized as an end-fed vertical folded dipole. As with all end fed dipoles some sort of impedance matching is necessary to keep the SWR down
The gamma match consists of a 150mm length of 10mm aluminium tubing
The gamma match consists of a 150mm length of 10mm aluminium tubing
To build it I use pieces of 450 Ohms leader line approx. 154cm, a PVC tube approx. 200cm, rope,SO-239 female connector, RG-58 about 1,5meter
Linear loaded short dipole 21Mhz For my amateur radio activities on the HF bands I only have a 3.6 m wide balcony available for antennas. After some study I decided to experiment with a shortened dipole for the 15 m band
Rx antennas 4Square Rx Vertical Array My frequency design of 1.825 MHz a 90 degrees line would be 33,70 metersinstead of the previously calculated 33,27 m
A simple SWR Meter is to be used at HF An SWR meter provides information about how well matched is your antenna with the transmitter and how well power is being radiated