Hits
A compact 2 element beam for 10M
I used two bamboo rods joined together with vinyl tape. The total length of the two rods is 3.35M 11ft. For the boom, I used a 2.1 metre length of fibreglass pole that
post 02 Mar 2024
Antenna Moxon Links →
40m Moxon yagi Antennna
In this antenna, 4 pieces of 6-7mt of fishing rod were used
10m Aluminium Moxon Construction
Bending the tubes was a challenge, I eventually borrowed a pipe bender for 15mm copper pipe and used this It worked satisfactorily and I used a hand held pipe cutter to cut the tubes
Six Meter Moxon Antenna
One fully portable 6m Moxon beam that breaks down into a bag easy carried off and easy to assemble in about ten minutes
20-meter Vertical Moxon
In the end the antenna ended up resonating closer to the upper edge of the 20m band around 14.275
Moxon for 70cm
The antenna is broadband, has a broad (100 degrees) front lobe, a good front-to-back ratio and a useful amount of forward gain and presents a decent near 50 ohm match at resonance
44
In this antenna, 4 pieces of 6-7mt of fishing rod were used
Bending the tubes was a challenge, I eventually borrowed a pipe bender for 15mm copper pipe and used this It worked satisfactorily and I used a hand held pipe cutter to cut the tubes
One fully portable 6m Moxon beam that breaks down into a bag easy carried off and easy to assemble in about ten minutes
In the end the antenna ended up resonating closer to the upper edge of the 20m band around 14.275
The antenna is broadband, has a broad (100 degrees) front lobe, a good front-to-back ratio and a useful amount of forward gain and presents a decent near 50 ohm match at resonance
Ferrite Shop Ferrite-shop on-line shop, cable clamps,toroids, cable cores, technic,ferrite material choice
Amateur radio kits by Kanga US
Pcs Electronics RF power amplifiers-pallets archives-ABC of FM AM DAB+ DRM radio transmitters