![](../copia_image/vote.jpg)
![](img/img.jpg)
Realization of a 27 MHz doublet
It is not always easy to fix a doublet between two high points in a clear place. One solution is to hang the center of the doublet as high as possible and anchor both ends
post 28 Jan 2024
![Realization of a 27 MHz doublet](images/a-27-mhz-doublet.jpg)
Antenna CB 27 MHz Links →
Coaxial-Antenner - 1,79 meter for 27 MHz
A 2 mm wire 1.79 meters long by 27 MHz. This antenna whip is shortened with an antenna coil. The coil of the antenna must have a diameter of 17 mm and have 17 turns that must be wrapped tightly against each other
Delta loop de 26-30 MHz 10-11m
a vertical polarization antenna ,with high efficiency and as small as possible
Flat eh antenna from 18 to 28 MHz BAND, UA1ACO
The antenna is fastened onto a wooden or plastic former to ensure that the operator ts head-body does not influence any antenna parameters
Ground CB antenna, OK1IKE
Antenna, shown in the picture, is characterized by simplicity and easy realizability, it occupies a minimum area of height slightly over 1.5 meters
80
A 2 mm wire 1.79 meters long by 27 MHz. This antenna whip is shortened with an antenna coil. The coil of the antenna must have a diameter of 17 mm and have 17 turns that must be wrapped tightly against each other
a vertical polarization antenna ,with high efficiency and as small as possible
The antenna is fastened onto a wooden or plastic former to ensure that the operator ts head-body does not influence any antenna parameters
Antenna, shown in the picture, is characterized by simplicity and easy realizability, it occupies a minimum area of height slightly over 1.5 meters
![Antenna switch arduino for icom IC-7300](/../antype/ch45/images/antenna-switch-arduino-for-i-com-ic-7300.jpg)
Antenna switch arduino for icom IC-7300 A solution built around an arduino nano and one of the readily available four relay switching boards