Hits
VLF nach KW-Konverter
- The schematic above is a simple up converter which i used in conjunction with a short-wave receiver to quite successfully to monitor solar flare activity a few years ago
post 14 Apr 2026
Antenna 136KHz Links →
The Loop ATU consists of a capacitive matching network 3 capacitors and a toroidal 4:1 balun. The balun is made using 18 bifilar-wound turns on a 58 mm
La bande 137 kHz
For 137 kHz the coil has about 200 turns of enameled wire
L.F. On-the-air
With UK amateurs having had access to 136kHz for several years, a lot of experience has been gained matching transmitters to a variety of LF antennas
LF Tuning Meter for the 136kHz Band
When adjusting the tuning and matching components of an LF antenna, it is extremely useful, if not essential, to havesome way of indicating the impedance mismatch at the antenna feed point
70
For 137 kHz the coil has about 200 turns of enameled wire
With UK amateurs having had access to 136kHz for several years, a lot of experience has been gained matching transmitters to a variety of LF antennas
When adjusting the tuning and matching components of an LF antenna, it is extremely useful, if not essential, to havesome way of indicating the impedance mismatch at the antenna feed point
All Spectrum Electronic All Spectrum Electronics Hobby Kits and Electronics Supply
Dxengineering Ham Radio Equipment DX Engineering Ham Radio Equipment & Supplies
BA-Electronics Ba-electronics, a division of products, has added electronic components, test equipment, wire, and supplies to its product offering