Hits 

The Sloping Vertical Dipole


A simple method for erecting the vertical part is the mounting of the wire on a fishing rod
post 16 Jun 2024
The Sloping Vertical Dipole

Antenna Vertical Links

185



80m full size 1/4 wave GPA
The 18m glassfibre pole from Spiderbeam - see The antenna itself is composed of 12m of heavy flexible insulated copper wire 4mm/2 section + 7m of same but 2,5 mm/2 on the top

A Home Brew HF Vertical From Copper Pipe
I sure have logged a lot of DX from all over the lower 48, Alaska and Canada with it! It's great for portable use or set it up for permanent station operation

A Practical 5-Band Homebrew Wire Beam
The 5-band hexbeam consists of three pieces of wire for each band. Two of the wires are deployed as a center-fed radiating element and the other acts as a director

A quarter wavelength for 40 meters
Vertical antenna 1/4 wavelength 64 radials, with remote tunner


23cm Yagi Antenna building

23cm Yagi Antenna building Finished antenna at 1275 MHz SWR under 1:1.5 at resonant frequency

50 MHz preamp Gain 26dB with the BFG135

50 MHz preamp Gain 26dB with the BFG135 Preamps for 144 and 430 MHz, for 50 MHz, the BFG135a is a cheap transistor and in my view rather strong. It is not easily damaged by static discharge or RF power. FG connection

30 Volt Computer Power Supply Stack

30 Volt Computer Power Supply Stack A bonus was that i discovered that these did not need a standby load connected to the supply to keep them running just apply mains power and close the Start lead to ground