Hits

DB37-FT-2000 Cable
can be used with the following microHAM interfaces
post 22 Jun 2024
Microphone Setting Links →
Kenwood MC-50 modification
There have been a few instances of improper VOX operation when the MC-50 microphone is used
Kenwood Mc-60 to Icom IC746
MC‐60APinConnections,BeforeandAfterModifications,forUsewithICOMRadios
Kenwood Pin Connectors
During the past eleven years many hours have been spent drawing diagrams producing photographs, compiling these lists and cross
Kenwood TR-7950 Microphone Pinout
I looked through the internet for a microphone pinout for this Kenwood I was given. The wires had been yanked from the mic connect
Low Noise Microphone Preamplifier
This is a design for a low noise microphone preamplifier, which is ideally suited to low impedance 600 Ohm nominal microphones
44
There have been a few instances of improper VOX operation when the MC-50 microphone is used
MC‐60APinConnections,BeforeandAfterModifications,forUsewithICOMRadios
During the past eleven years many hours have been spent drawing diagrams producing photographs, compiling these lists and cross
I looked through the internet for a microphone pinout for this Kenwood I was given. The wires had been yanked from the mic connect
This is a design for a low noise microphone preamplifier, which is ideally suited to low impedance 600 Ohm nominal microphones
eYou.com.au RF shop Test Instruments, RF Coaxial Cable, RF Coaxial Connectors, Coaxial Attenuators, Supplier in Australia, melbourne

