Hits
End feed Antenna for HF Bands
It is a simple half wave wire antenna computed for the lower band which begin worked. On the other bands working onharmonics. The feed point of this antenna applied on the one end
post 15 Jun 2024
Antenna End Fed Links →
End fed antenna lambda/2
drastically lower the impedance with a toroid FT240-43 on which we are going to wrap 14 + 2 coils of copper from 1mm
End fed 1/2 wave matching system end feed
Actual bandwith is more than 2 Mhz with VSWR better than 1:1,7 For 14 Mhz you need approx. 10 meters of wire, abt. 4,7m coax-cable 50Ohm or 300Ohm with a connector about 30cm from the shortend end
End-Fed Half-Wave Antenna & Tuner
The final device tunes a resistive load of 3-7 kilo-Ohms from 3.2 MHz to 12.6 MHz. 40 metres is covered and 30 metres too, but I lack a transceiver for it currently
HF End Fed Half Wave
The SWR is likely to be below 1:1.5 and when used as an omnidirectional vertical the low angle of radiation typically with a maximum at about 20 degrees will give good results on DX
63
drastically lower the impedance with a toroid FT240-43 on which we are going to wrap 14 + 2 coils of copper from 1mm
Actual bandwith is more than 2 Mhz with VSWR better than 1:1,7 For 14 Mhz you need approx. 10 meters of wire, abt. 4,7m coax-cable 50Ohm or 300Ohm with a connector about 30cm from the shortend end
The final device tunes a resistive load of 3-7 kilo-Ohms from 3.2 MHz to 12.6 MHz. 40 metres is covered and 30 metres too, but I lack a transceiver for it currently
The SWR is likely to be below 1:1.5 and when used as an omnidirectional vertical the low angle of radiation typically with a maximum at about 20 degrees will give good results on DX
Antenna splitter per VHF-UHF per quattro ricevitori Chi dispone di una sola antenna e vuole collegarvi più di un ricevitore necessità di uno splitter
Amateur radio kits by Kanga US
50MHz to 28MHz RX Converter The concept of the rx converter is quite simple and nothing really new. the local oscillator is a standard colpitts crystal oscillator producing the 22mhz lo signal