Hits 

Multi band end-fed


The heart of the multiband end-fed is a 1:50 to 1:60 impedance transformer that feeds half a wave of wire fed at the end or beginning where impedance is very high aroun 3k Ohms
post 30 Mar 2024
Multi band end-fed

Antenna End Fed Links

67



EFHWA tuner
Un tipo un balun 1:7 oppure 1:8 per fronteggiare gli ohm presenti ai vertici della nostra antenna, quindi 3 giri di avvolgimento primario e 21 o 22 di secondario andranno bene. per quanto riguarda il ROS non salgo mai sopra 1.6-1.8

Endfed per 17-20-30-40 metri
Una veloce multibanda E.F.W.H.A. dedicata ai piccoli quadri banda come il mio FT857D

End fed 1/2 wave matching system end feed
End-fed antennas are increasingly popular again, at least partly because of compact iron toroid cores. Small soft-iron cores allow compact, easy-to-build, low-power transformers and networks

End fed antenna lambda/2
Un trasformatore 1:64 su cui e' collegato un filo lungo lambda/2 della frequenza prescelta. una versione a 3 o 5 bande in modo da avere maggiori chance su piu' frequenze. Un filo di rame teso ha un'impedenza superiore ai 3.3 K ohm e quindi per poter adattare l'impedenza ai 50 ohm della radio, con un toroide FT240-43 - 1:64

An EFHW antenna for 160-10m band
An efhw as inverted-l from the feedpoint at the edge of property, about 10m upwards into the direction roof ridge


eYou.com.au RF shop

eYou.com.au RF shop Test Instruments, RF Coaxial Cable, RF Coaxial Connectors, Coaxial Attenuators, Supplier in Australia, melbourne

Radioassistance

Radioassistance Radioassistance E Kenwood Dealer, vendita ricetrasmittenti, antenne, parti di ricambio, elettronica

SunCalc

SunCalc SunCalc - sunrise, sunset, shadow length, solar eclipse, sun position, sun phase, sun height, sun calculator, sun movement, map, sunlight phases, elevation, Photovoltaic