Hits
Long Wire Balun
I needed about 60 cm wire 1 mm to be able to have 11 turns around the iron powder core
post 02 Apr 2024
Toroid & balun Links →
4 to 1 balun
This balun was made with two ferrite cores, Jaycar LF1258)wired using Cat 5 UTP wire. The winding ratio is 6 turns to 12 turns. 50 ohm primary is 6 turns. The 200 ohm secondary is formed by adding 3 turns to either end, giving 12 turns overal
6:1 Voltage Balun
Requiring a balun to feed a balanced antenna from an un-balanced load with a impedance step up from 50ohms to 300ohms, a 1:6
9:1 transformer
A balanced antenna from an un-balanced load with a impedance step up from 50ohms to 300ohms, a 1:6 Voltage balun design using two L15 ferrite toroid cores was selected
9 to 1 balun
This balun was made with single ferrite core, Jaycar L01234) wired using single strand Cat 5 UTP wire. The winding ratio is 6 turns to 18 turns. 50 ohm primary is 3 x 6 turns, wired in parallel. The 450 ohm secondary is formed by winding 2 x 9 turns in series
209
This balun was made with two ferrite cores, Jaycar LF1258)wired using Cat 5 UTP wire. The winding ratio is 6 turns to 12 turns. 50 ohm primary is 6 turns. The 200 ohm secondary is formed by adding 3 turns to either end, giving 12 turns overal
Requiring a balun to feed a balanced antenna from an un-balanced load with a impedance step up from 50ohms to 300ohms, a 1:6
A balanced antenna from an un-balanced load with a impedance step up from 50ohms to 300ohms, a 1:6 Voltage balun design using two L15 ferrite toroid cores was selected
This balun was made with single ferrite core, Jaycar L01234) wired using single strand Cat 5 UTP wire. The winding ratio is 6 turns to 18 turns. 50 ohm primary is 3 x 6 turns, wired in parallel. The 450 ohm secondary is formed by winding 2 x 9 turns in series
Take off angle of horizontal antenna For horizontal polarization, the electric field will move sideways on a horizontal plane, while for vertical polarization it will oscillate up and down on a vertical plane
Rx antennas 4Square Rx Vertical Array My frequency design of 1.825 MHz a 90 degrees line would be 33,70 metersinstead of the previously calculated 33,27 m
Calculo da Antena Bazooka A double bazooka antenna is a combination that has a complete coaxial wave multiplied by its velocity factor and a total end-to-end length of 1/4 wave for each side affected by another driver shortening facto