Hits 

Balanced Terminated Folded Dipole


Designed my btfd to operate on a minimum frequency of 1.8 mhz with an intended use spaning from 1.9 to 11.0 mhz
post 04 Feb 2024
Balanced Terminated Folded Dipole

Antenna 40 Meter Links

73



Shortened with 40 turns trap 7 mhz Dipole
To construct each side of the antenna proceed as follows. Cut a 10.25 metre length of 24/0.076 insulated wire, and a 160 mm length of 40 mm o.d plastic tubing

Shortening your dipole
Loaded dipole antenna that is intended to fit in available space

Sloper sloping dipoles 40mt-80mt
Having only a single vertical support or limited horizontal space might be a problem.Such a problem can be solved by mounting a dipole at a slope

Super gain antenna project for 40 meters
It is based on the theory of super gain NVIS arrays, which reject QRM from low angles and produces a very high angle of radiation

Short Antenna per le HF
L'antenna e fatta da 3 parti, la parte radiante con la sua capacita


Linear-loaded-short-dipole-21mhz

Linear loaded short dipole 21Mhz For my amateur radio activities on the HF bands I only have a 3.6 m wide balcony available for antennas. After some study I decided to experiment with a shortened dipole for the 15 m band

Rx antennas 4Square Rx Vertical Array

Rx antennas 4Square Rx Vertical Array My frequency design of 1.825 MHz a 90 degrees line would be 33,70 metersinstead of the previously calculated 33,27 m

A simple SWR Meter is to be used at HF

A simple SWR Meter is to be used at HF An SWR meter provides information about how well matched is your antenna with the transmitter and how well power is being radiated