Hits
4:1 coax balun design Calculator
Here we calculate the half wave length of the matching section of the 4:1 coax balun. Again the equations are taken from the ARRL Antenna Book
post 06 Feb 2024
Toroid & balun Links →
Balun un-un
Il diametro di ogni singolo conduttore rosso o nero e' di 2 mm plastica compresa, e di 0.75 mm senza isolante plastico
Balun
For some so-called baluns, no throttling action or effect against common-mode currents will be measurable. This means that sheath waves occur and the coaxial cable outer screen acts as an antenna. Domestic interference fields penetrate unhindered over the alleged balun in the receiver
Welcome to Balun Designs LLC
Enter the frequency of operation and the balanced and unbalanced Z0.Values for L and C will be calculated
Popular high power baluns
Transformers, Inductors, Chokes and Coils custom designs, standard stocking parts
Balun 4:1 in aria
Varie fasi della costruzione di un balun in aria 1:4 per alimentare una antenna long wire tipo canna da pesca o simili
205
Il diametro di ogni singolo conduttore rosso o nero e' di 2 mm plastica compresa, e di 0.75 mm senza isolante plastico
For some so-called baluns, no throttling action or effect against common-mode currents will be measurable. This means that sheath waves occur and the coaxial cable outer screen acts as an antenna. Domestic interference fields penetrate unhindered over the alleged balun in the receiver
Enter the frequency of operation and the balanced and unbalanced Z0.Values for L and C will be calculated
Transformers, Inductors, Chokes and Coils custom designs, standard stocking parts
Varie fasi della costruzione di un balun in aria 1:4 per alimentare una antenna long wire tipo canna da pesca o simili
Antenna switch arduino for icom IC-7300 A solution built around an arduino nano and one of the readily available four relay switching boards
Antenna helix per oscar 100 Helix antenna diametro 4 mm- 6 spre su diametro di 40 mm- con spire distanziate tra loro di 25 mm
30 Volt Computer Power Supply Stack A bonus was that i discovered that these did not need a standby load connected to the supply to keep them running just apply mains power and close the Start lead to ground