Hits 

Balun test


Balun test

The source and load at Balun are simulated with resistors. These always bring a few ohms into the current path, which additionally introduce damping into the result

post 27 Oct 2024


Toroid & balun Links

203



1:4 Guanella-Balun Current-Balun
The purpose of this article is to show how a 1:4 Guanella current balun changes an impedance level by a multiplier of four; for example, 50-ohm coax to a 200-ohm antenna

Constructing a 6:1 RF transformer
If it's using used a 50 Ohm coaxial transmission line, the main problem in constructing a 1:1 current balun using bifilar windings is that you have to get the impedance of the transmission line formed by the two parallel wires exactly correct

Balun & Chokes
I chose the LFB095051 ferrite tubes - sleeves with similar characteristics to the Mix31, therefore excellent for 80 and 160

9:1 Impedance Transformer
a 9:1 unbalanced to unbalanced UNUN impedance transformer, is to experiment with an Inverted V end fed antenna for 80 to 17m, I'm not aiming for transmission on 12 and 10m


Antenna splitter per VHF-UHF per quattro ricevitori

Antenna splitter per VHF-UHF per quattro ricevitori Chi dispone di una sola antenna e vuole collegarvi più di un ricevitore necessità di uno splitter

Kits and Components

Amateur radio kits by Kanga US

50MHz to 28MHz RX Converter

50MHz to 28MHz RX Converter The concept of the rx converter is quite simple and nothing really new. the local oscillator is a standard colpitts crystal oscillator producing the 22mhz lo signal