Bazooka GP 1/4 lambda vertical for the 40m

Bazooka GP vertical a omnidirectional antenna for the 40m
post 25 Jan 2024
Bazooka GP 1/4 lambda vertical for the 40m

Antenna Bazzoka Links


Double bazooka coaxial dipole broad-band, W5BGP
The inside sections, do not radiate, but act as quarter-wave shorted stubs which presents high resistive impedance to the feed point at resonance and tends to cancel reactance as frequence off resonant frequencies

Double Bazooka Dipole
consist of a half wavelength piece of coax RG58 with the shield split at the center and the feedline attached to the open ends

Antenne double-bazooka
The double-bazooka consists of 1/2 lambda of coaxial cable cut at its center or twice 1/4 lambda

Double bazooka Antennen
My measurements that I used successfully: Band: Coaxial length: 30m 9.77m 2.03m (30cm longer left to vote) 40m 13.99m 2.904m (30cm longer to vote) 80m 26.77m 5.41m


Linear loaded short dipole 21Mhz For my amateur radio activities on the HF bands I only have a 3.6 m wide balcony available for antennas. After some study I decided to experiment with a shortened dipole for the 15 m band

Rx antennas 4Square Rx Vertical Array

Rx antennas 4Square Rx Vertical Array My frequency design of 1.825 MHz a 90 degrees line would be 33,70 metersinstead of the previously calculated 33,27 m

Atu balanced feeder antenna system

Atu balanced feeder antenna system An ATU has the advantage of bringing the feeder-antenna system to resonance, act as a band pass filter both on receive and transmit and a low SWR