Hits
Arduino RF power & SWR meter
My primary interest was for VHF/UHF/SHF, I have foreseen positions for 6m, 4m, 2m, 70 cm, 23cm and 13cm bands - but you can use the ARDUINO readout on HF as well
post 24 Jan 2024
Swr Meter Links →
A Mini Primer on SWR Measurements
Every radio ham needs an SWR meter. Even though comercial rigs have builtin digital readout SWR meters
A Small Digital QRP SWR Meter with OLED Display
Most accept that transmitters operate best when the power output is connected to a load which presents an SWR below 2:1. For example, 100 ohms, 25 ohms
Antenna Reflection and SWR Calculator
VSWR return loss and reflection coefficient, which are different ways to express how well a load is matched to a source
Arduino RF power & SWR meter
my primary interest was for vhf/uhf/shf, i have foreseen positions for 6m, 4m, 2m, 70 cm, 23cm and 13cm bands - but you can use the arduino readout on hf as well
83
Every radio ham needs an SWR meter. Even though comercial rigs have builtin digital readout SWR meters
Most accept that transmitters operate best when the power output is connected to a load which presents an SWR below 2:1. For example, 100 ohms, 25 ohms
VSWR return loss and reflection coefficient, which are different ways to express how well a load is matched to a source
my primary interest was for vhf/uhf/shf, i have foreseen positions for 6m, 4m, 2m, 70 cm, 23cm and 13cm bands - but you can use the arduino readout on hf as well
Linear loaded short dipole 21Mhz For my amateur radio activities on the HF bands I only have a 3.6 m wide balcony available for antennas. After some study I decided to experiment with a shortened dipole for the 15 m band
Rx antennas 4Square Rx Vertical Array My frequency design of 1.825 MHz a 90 degrees line would be 33,70 metersinstead of the previously calculated 33,27 m
A simple SWR Meter is to be used at HF An SWR meter provides information about how well matched is your antenna with the transmitter and how well power is being radiated