Hits
The Z-Match Tuner with toroid T-200-6
This is a good little tuner it cost me about $60 to build
post 13 Sep 2024
Antenna Transmatch tuner Links →
Pi-filter ATU voor Beams en Verticals
An antenna tuner for coaxial cable powered resonance antennas, such as beams and verticals for 10 to 20 m, can easily be made with normal components
QRP Antenna Tuner
The tuner was built in an aluminum project box. Various holes were drilled in the box for mounting all of the components. When laying out the parts, leave plenty of room around the sides of the components to prevent RF arcing
S match A symmetrical and universal ATU
The Balanced Universal ATU System. The system is intended to accommodate balanced antenna systems transmitting on a very wide frequency spectrum, ranging from 160 m band up to 10 m band
197
An antenna tuner for coaxial cable powered resonance antennas, such as beams and verticals for 10 to 20 m, can easily be made with normal components
The tuner was built in an aluminum project box. Various holes were drilled in the box for mounting all of the components. When laying out the parts, leave plenty of room around the sides of the components to prevent RF arcing
The Balanced Universal ATU System. The system is intended to accommodate balanced antenna systems transmitting on a very wide frequency spectrum, ranging from 160 m band up to 10 m band
Antenna switch arduino for icom IC-7300 A solution built around an arduino nano and one of the readily available four relay switching boards
50 MHz preamp Gain 26dB with the BFG135 Preamps for 144 and 430 MHz, for 50 MHz, the BFG135a is a cheap transistor and in my view rather strong. It is not easily damaged by static discharge or RF power. FG connection
30 Volt Computer Power Supply Stack A bonus was that i discovered that these did not need a standby load connected to the supply to keep them running just apply mains power and close the Start lead to ground