Hits
Meteo Fax and RTTY frequencies
Here are some weather fax frequencies classified by region, from various internet sources
post 25 Jan 2024
About Rtty mode Links →
RTTY Modes
rtty has been used by radio amateurs since the 1950s. initially an electromechanical system designed for use on telephone wires, it was not conceived as a radio system
RTTY operation N1MM logger setup
There is a new How-To Guide on how to setup N1MM Logger+ with MMTTY and 2Tone to run RTTY for causal operation or in a contest
WriteLog RTTY Starter
writelog is the best rtty contest software available on the market today. there are other software packages that will work for rtty contesting
BTL Blaster TeLetype
blaster teletype btl 1.51 and written by robert glassey, g0vtq. athough it works under dos and in a dos box under windows 95 it is one of the best programs for rtty with a soundblaster card i have seen
RTTY.com
Rtty.com has been established to focus on the many aspects of amateur radio teletype
28
rtty has been used by radio amateurs since the 1950s. initially an electromechanical system designed for use on telephone wires, it was not conceived as a radio system
There is a new How-To Guide on how to setup N1MM Logger+ with MMTTY and 2Tone to run RTTY for causal operation or in a contest
writelog is the best rtty contest software available on the market today. there are other software packages that will work for rtty contesting
blaster teletype btl 1.51 and written by robert glassey, g0vtq. athough it works under dos and in a dos box under windows 95 it is one of the best programs for rtty with a soundblaster card i have seen
Rtty.com has been established to focus on the many aspects of amateur radio teletype
23cm Yagi Antenna building Finished antenna at 1275 MHz SWR under 1:1.5 at resonant frequency
50 MHz preamp Gain 26dB with the BFG135 Preamps for 144 and 430 MHz, for 50 MHz, the BFG135a is a cheap transistor and in my view rather strong. It is not easily damaged by static discharge or RF power. FG connection
30 Volt Computer Power Supply Stack A bonus was that i discovered that these did not need a standby load connected to the supply to keep them running just apply mains power and close the Start lead to ground