Hits
New Groundmounted 80m 4 square
The thre lower alloy poles are 15m tall in total. Plus the 6 spoke capacity hat 6x 140cm I was resonant at 3800 khz. Maybe when I add the perimeter alloywire around the 6 spokes I will be at 3750
post 01 Apr 2024
Antenna 40 Meter Links →
Shortened with 40 turns trap 7 mhz Dipole
To construct each side of the antenna proceed as follows. Cut a 10.25 metre length of 24/0.076 insulated wire, and a 160 mm length of 40 mm o.d plastic tubing
Shortening your dipole
Loaded dipole antenna that is intended to fit in available space
Sloper sloping dipoles 40mt-80mt
Having only a single vertical support or limited horizontal space might be a problem.Such a problem can be solved by mounting a dipole at a slope
Super gain antenna project for 40 meters
It is based on the theory of super gain NVIS arrays, which reject QRM from low angles and produces a very high angle of radiation
Short Antenna per le HF
L'antenna e fatta da 3 parti, la parte radiante con la sua capacita
73
To construct each side of the antenna proceed as follows. Cut a 10.25 metre length of 24/0.076 insulated wire, and a 160 mm length of 40 mm o.d plastic tubing
Loaded dipole antenna that is intended to fit in available space
Having only a single vertical support or limited horizontal space might be a problem.Such a problem can be solved by mounting a dipole at a slope
It is based on the theory of super gain NVIS arrays, which reject QRM from low angles and produces a very high angle of radiation
L'antenna e fatta da 3 parti, la parte radiante con la sua capacita
Take off angle of horizontal antenna For horizontal polarization, the electric field will move sideways on a horizontal plane, while for vertical polarization it will oscillate up and down on a vertical plane
Rx antennas 4Square Rx Vertical Array My frequency design of 1.825 MHz a 90 degrees line would be 33,70 metersinstead of the previously calculated 33,27 m
Calculo da Antena Bazooka A double bazooka antenna is a combination that has a complete coaxial wave multiplied by its velocity factor and a total end-to-end length of 1/4 wave for each side affected by another driver shortening facto