Hits 

A Cost Effective Current-Mode 1:4 Balun


A cost effective current-mode 1:4 balun can be constructed from two lengths of coax, two ferrite rods
post 26 Apr 2024
A Cost Effective Current-Mode 1:4 Balun

Toroid & balun Links

210



1:4 Balun, ON6MU
Balun for folded dipoles

4:1 balun for 160 to 10 meters
Here we calculate the half wave length of the matching section of the 4:1 coax balun

4:1 coax balun design CALCULATOR
Here we calculate the half wave length of the matching section of the 4:1 coax balun

50 ohm single-band baluns
The balun herein described is suitable for 50-ohm monoband antennas which can often represent a valid choice

JI -Test, measure balun, and compare antenna baluns or balums
Many articles and technical sources on baluns or balun design ignore voltage, focusing only on current. Focusing only on current is a serious oversight that can result in defective system design


Linear-loaded-short-dipole-21mhz

Linear loaded short dipole 21Mhz For my amateur radio activities on the HF bands I only have a 3.6 m wide balcony available for antennas. After some study I decided to experiment with a shortened dipole for the 15 m band

Rx antennas 4Square Rx Vertical Array

Rx antennas 4Square Rx Vertical Array My frequency design of 1.825 MHz a 90 degrees line would be 33,70 metersinstead of the previously calculated 33,27 m

A simple SWR Meter is to be used at HF

A simple SWR Meter is to be used at HF An SWR meter provides information about how well matched is your antenna with the transmitter and how well power is being radiated